Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installing the motor unit on the valve
and making the connections:
Figures 3 and 4, page 3
1.
Check the rotation direction of the valve. By
default, the valve is right-handed = opens
clockwise.
2.
Position the valve to zero and remove the
knob (for Termomix type valves, install the
rotation-preventing screw at this point).
3.
Install the adapter on the valve stem and
make sure that it is fully in place. Install the
motor unit on the valve. At this point, make
sure that the motor is also positioned to zero
= it has the same position as the valve. MAKE
SURE THAT SWITCH D IS SET TO MANUAL
OPERATION (HAND SYMBOL) AND USE
THE HANDLE TO CHECK THE OPERATION
OF THE VALVE.
4.
Install the two-sided indicating panel in place
so that the indicator of the handle points at
the zero position when the valve is closed.
5.
Tighten the screw to fasten the motor in place
and rotate the handle to check that the valve
can easily be turned 90 degrees. Leave the
equipment at the zero position and set switch
D to AUTOMATIC OPERATION (A).
NOTE!
First power on the room unit and only then
the motor unit!
www.vexve.com
6.
Use the provided ties to fasten the supply
water sensor to the supply water pipe and
connect it to connector B of the motor unit.
It is good to insulate the sensor in order to
ensure proper operation.
7.
Connect the RF transmitter (page 2, figure 2)
cable between the transmitter and the motor
unit connector C. Mount the transmitter on a
wall as high as possible, or hang it from the
ceiling if wall-mounting is not available (this
improves the range of the transmitter).
8.
Slide down the back/wall-mount plate of the
room unit to remove it. Remove the plastic
protecting the batteries. The room unit pow-
ers on, and "RU" appears on the display.
9.
Connect the transformer to connector A and
plug the transformer into a power outlet.
10. Check that the LED of the RF transmitter is
blinking.
After these steps, continue with the section "Basic
settings of the room unit during setup", p. 41.
NOTE!
When the equipment powers on, it is avail-
able for pairing for five minutes!
EN
35
Werbung
