Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Refer to the Machine Description section to identify all components mentioned in this section.
CHARGING THE BATTERY PACK
CAUTION
1. Plug the charger into an AC power outlet.
2. Insert the battery pack into the charger.
battery status. They are as follows:-
LED Status
Description
* Refer to the Troubleshooting Guide.
INSERTING THE BATTERY PACK
1. Select a compatible battery and check that it is in good operational condition. If the battery shows signs of impact damage, emits an
unusual smell, feels hot DO NOT USE
battery into the motor housing.
3. Open the protective top cover lid on the mixer handles and open the battery cover on the motor housing.
4. Hold the battery with 2 hands. One hand should grab the battery from the top with the charge display facing upwards, gripping it
across the 2 short sides. The second hand should hold the battery around the middle.
5. Turn the battery until the retaining lug lines up with the battery retaining clip.
6. Slide the base of the battery into its housing locating the slide rails.
7. Remove your hand from the middle keeping hold of the battery from the top and allow the battery to slide fully into the housing.
8. Once fully inserted, press lightly down on the top of the battery until the battery retaining latch, clicks into position and locks the
battery in place.
10. Close the battery cover and the top cover lid.
11. The mixer is now ready for operation.
EMERGENCY STOP
can be stopped by removing the isolator key, or removing the battery.
STOPPING THE POWER UNIT
1. Press the red STOP (O) button to the right-hand side of the power unit and the power unit will stop.
2. ENSURE the isolator key is removed from the power unit.
STARTING THE POWER UNIT
1. INSERT the isolator key into the power unit.
2. Press the green START (I) button to the right-hand side of the power unit and the power unit will start.
Operating Instructions
The battery pack is not shipped fully charged. It is recommended to fully charge before use to ensure that
maximum run time can be achieved.
Blinking Green
Charging
Solid Green
Fully Charged
*Over Temperature
RED STOP button. In the case of a Stop button failure the mixer
35
Solid Red
Blinking Red
*Charging Fault
GB
Werbung
