Einhell bavaria 45.106.83 Bedienungsanleitung Seite 6

Anleitung BAS 3_6 LI Set_SPK1:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the booklet included in delivery for
the safety instructions.
2. Layout
1 Lamp
2 Bit chuck
3 Changeover switch for forward/reverse
4 Charging connection
5 ON/OFF switch for lamp
6 Battery charger
7 Battery capacity indicator
8 Control lamp for charging
9 Charging cable
10 ON/OFF switch
3. Proper use
The cordless screwdriver is designed for tightening
and undoing screws.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Important information
Be sure to read the following information before you
use your cordless screwdriver for the first time:
1. Charge the battery pack with the charger
supplied. An empty battery pack requires a
charging period of approximately 5 hours.
6
23.05.2007 15:50 Uhr
2. Only ever use sharp drill bits and screwdriver bits
which are suitable for the purpose and in faultless
condition.
3. Always check for concealed electric cables and
gas and water pipes when drilling and screwing in
walls.
5. Starting up
Charging the LI-I battery pack
1. Check that your mains voltage is the same as that
marked on the rating plate of the battery charger.
Plug the battery charger in the socket-outlet and
connect the charging cable to the charging
connection.
2. The red LED (8) will come on to indicate that the
battery pack is being charged.
3. An empty battery pack requires a charging period
of approximately 5 hours. The charging control
lamp (8) goes out when charging is completed.
Important! The rechargeable battery may become
a little warm during the charging process. This is
normal.
If the battery pack fails to become charged, please
check
whether there is voltage at the socket-outlet
whether there is proper contact at the charging
contacts on the charger.
If the battery still fails to become charged, please
return
the charger
the screwdriver
to our Customer Service Department.
Timely recharging of the LI-I battery pack is
recommended in the interest of long battery life.
Recharging is always necessary when you notice
that the power of the battery-powered
drill/screwdriver is decreasing.
Never allow the battery pack to discharge
completely. This will result in damage to the LI-I
battery pack!
Forward/reverse changeover switch (3)
You can select between clockwise and counter-
clockwise rotation. Change the direction of rotation
only when the screwdriver is at a standstill. If you fail
Seite 6