Assembly Instructions; Assembly Of The Legs; Installation In Bathrooms - Create Warm Clear IR Bedienungsanleitung

Before installing the product, check that all parts are present and that the product is not
defective.
If you want to use the heater independently, attach the supplied legs following these assem-
bly instructions.
The heater must be mounted on a clean, stable and level surface.
AS SE MB LY OF T HE LEGS
INSTALL ATI ON IN BAT H ROO MS
If you want to install the heater in the bathroom, take into account the following safety in-
structions for proper installation.
For protection against electric shock, only products with the appropriate IP rating may be
used. This classification indicates the distance that the product must respect a water source.
Our product achieves the IP24 classification, so it can be installed in the areas indicated in
the following illustration.
Be sure to respect the distance with walls and objects.

ASSEMBLY INSTRUCTIONS

1. Place the product face down on a soft cot-
ton cloth or rug.
2. Attach the legs to the base of the heater
using the supplied screws. Align the holes
in the base with the holes in the legs, insert
the screws into the holes and tighten with a
screwdriver (not included).
3. Then gently turn the heater over again and
place it on the ground.
E NGLI SH 9