Wall Installation - Create Warm Clear IR Bedienungsanleitung

WA L L I N STALL ATI ON
1. Carefully remove the hanger bracket al-
ready installed on the rear of the heater.
Rotate the two plastic safety handles lo-
cated on top of the stand. We recommend
that you do this several times to familiar-
ize yourself with the practice before fix-
ing it on the wall.
3. Drill the holes in the wall with a Ø8mm
drill bit and insert the corresponding
plastic plugs.
10 E NGL I SH
2. Use the bracket as a template and place
it level on the wall as a guide to mark the
position where you will put the hooks
(make sure the holes are parallel). With
a pencil mark the exact position of the
holes.
4. Securely attach the hanging bracket to
the wall with the supplied screws. Make
sure the hanging bracket is in the cor-
rect direction.
5. Gently insert the bottom of the heater into
the bracket, then push the upper body of
the heater onto the bracket to hang. We
recommend that you do this several times
before fixing it on the wall.
When the heater is attached to the bracket,
secure it in place by turning the two locking
handles with a long screwdriver.
Note: Before plugging in the unit, make sure
the heater is securely attached to the wall.