Maintenance And Cleaning; General Information About Radio Operation - eQ-3 homematic IP HmIP-PDT-CH Installations- Und Bedienungsanleitung

until the LED will quickly start flashing orange (see figure 3).
• Release the system button again.
• Press and hold down the system button again for 4 seconds, until
the status LED lights up green.
• Release the system button to finish the procedure.
The device will perform a restart.
10

Maintenance and cleaning

The device does not require you to carry out any maintenance. En-
list the help of an expert to carry out any maintenance or repairs.
Before cleaning the device, unplug it from the socket outlet. Use a dry linen
cloth to clean the device. If the device is particularly dirty, you can slightly
dampen the cloth to clean it. Do not use any detergents containing sol-
vents, as they could corrode the plastic housing and label. Make sure that
no moisture will ingress into the housing.
11

General information about radio operation

Radio transmission is performed on a non-exclusive transmission path,
which means that there is a possibility of interference occurring. Inter-
ference can also be caused by switching operations, electrical motors or
defective electrical devices.
The range of transmission within buildings can differ greatly from
that available in the open air. Besides the transmitting power and the
reception characteristics of the receiver, environmental factors such
as humidity in the vicinity have an important role to play, as do on-
site structural/screening conditions.
Hereby, eQ-3 AG, Maiburger Str. 29, 26789 Leer/Germany declares
that the radio equipment type Homematic IP HmIP-PDT-CH is in
compliance with Directive 2014/53/EU. The full text of the EU dec-
laration of conformity is available at the following internet address:
www.eq-3.com
Maintenance and cleaning
29