Operation; Response To Power Recovery - eQ-3 homematic IP HmIP-PDT-CH Installations- Und Bedienungsanleitung

Operation

After adding, you can simply plug in loads into the switched-off plugga-
ble dimmer and dim as well as switch devices on or off. Especially ob-
serve the safety instructions in the chapters see „2 Hazard information"
on page 21 and see „6 Operation" on page 26.
6 Operation
After adding and installing have been performed, simple operations are
available directly on the device.
Press the system button (A) shortly to switch connected loads on
•
and off.
Press and hold down the system button (A) to lower or increase
•
the brightness level of your connected loads.
Improper usage or a defective installation (e.g. low-quality or
defective plugs or sockets) can lead to overheating of the pluggable
dimmer. The integrated temperature control automatically switches
off the load. The devices is protected against overheating and secure
operation is ensured. As soon as the temperature reaches a non-
critical value, you can switch on the pluggable dimmer again. Always
observe the permitted ambient temperature of the device and, if
necessary, have the installation checked for possible error sources
by an expert.
Switching on of loads during power-on state (dimming level une-
qual to 0) is not permitted. Doing so may generate very high inrush
currents that can destroy the device.
7

Response to power recovery

After the device has been inserted to a socket or after power recovery the
pluggable dimmer performs a self-test/restart (approx. 2 seconds). The
device LED flashes orange and green briefly (LED test display). The LED
will flash if an error is detected during this test (see „8.3 Error codes and
flashing sequences" on page 28). This is repeated continuously and
the device does not perform its function. If the test is completed without
errors, the pluggable dimmer transmits a wireless telegram containing its
status information.
26