Error Codes And Flashing Sequences; Restore Factory Settings - eQ-3 homematic IP HmIP-PDT-CH Installations- Und Bedienungsanleitung

Restore factory settings

8.3

Error codes and flashing sequences

Flashing code
Short orange flash-
ing
1x long green light-
ing
1x long red lighting Transmission
Short orange flash-
ing (every 10 s)
1x long red lighting Transmission
6x long red flashing Device
1x orange and 1 x
green lighting (after
plugging into a
socket)
9 Restore factory settings
The factory settings of the device can be restored. If you do this, you
will lose all your settings.
To restore the factory settings of the pluggable dimmer, please proceed
as follows:
• Unplug the device from the socket (see figure 2).
• Plug in the device into the socket again while pressing and hold-
ing down the system button (A) for 4 seconds at the same time,
28
Meaning
Radio transmis-
sion/attempting
to transmit/data
transmission
Transmission
confirmed
failed
pairing mode
active
failed or duty
cycle limit is
reached
defective
Test display
Solution
Wait until the transmission is
completed.
You can continue operation.
Please try again (see see „8.1
Command not confirmed" on
page 27).
Please enter the last four
numbers of the device number
to confirm (see see „5.1 In-
stallation and pairing" on page
25).
Please try again (see sec. see
„8.1 Command not confirmed"
on page 27 or see „8.2 Duty
cycle" on page 27).
Please see your app for er-
ror message or contact your
retailer.
Once the test display has
stopped, you can continue.