Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Preset values are displayed when the "
stopping.
To start/stop operation
To set the operation mode
G Operation mode setting
G Room temperature setting
Raise
Lower
G Fan speed setting
• Wait 3 seconds after the operation settings are completed. After 3 seconds, the operation settings are trans-
mitted. (
flashes)
" button, the "
Press the "
" button to select ON or OFF for indoor unit.
OFF
ON
Press the "
" button to select the operation mode.
*
(AUTO)
(COOL)
* A heat pump model that is not set up as an Administrative Indoor Unit cannot operate
in the AUTO mode.
** FAN cannot be selected for a heat pump model.
*** HEAT cannot be selected for a cooling only model.
Refer to details in the Administrative Indoor Unit OPERATING TIPS.
• If the priority mode is set to "Priority on Administrative Indoor Unit", the operating
mode of other indoor units except Administrative Indoor Unit will be controlled by an
Administrative Indoor Unit.
• If the operating mode of Administrative Indoor Unit is set to "AUTO", "AUTO" is
displayed in addition to the display of current operating mode on other wired remote
controllers except Administrative Indoor Unit. In this case, operation of other indoor
units is controlled by the Administrative Indoor Unit.
Example: When operating mode of the Adminis-
trative Indoor Unit is set to "AUTO" while
air conditioning setting. (The indication
on other wired remote controllers except
Administrative Indoor Unit).
Press the "
" button or "
Temperature setting range
AUTO ............................................................ 18 to 30 °C (64 to 88 °F)
COOL/DRY .................................................... 18 to 30 °C (64 to 88 °F)
HEAT ............................................................. 10 to 30 °C (48 to 88 °F)
The set temperature cannot be set during the FAN mode.
(The temperature will not appear on the remote controller's display.)
* According to the initial setting, the heating temperature range from 10 to 15 °C (48
to 58 °F) cannot be set. In addition, the temperature range from 10 to 15 °C (48 to
58 °F) is invalid depending on the model even if it can be set.
Press the " " button to select the fan speed.
(AUTO)
* If DRY is selected, the fan speed can be set to AUTO only.
" button or "
" button, the " " button is pressed while
**
(DRY)
(FAN)
(HEAT)
" button to set the room temperature.
(MED)
(HIGH)
***
When Administra-
tive Indoor Unit is
set to "AUTO".
(LOW)
En-4
Werbung
