Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Ejoy FD
| Electric wheelchair
Ejoy FD XL
| Electric wheelchair
Ejoy FD XXL
| Electric wheelchair
sleeve on the push handle (Fig. 11) does not tilt during the proce-
dure, if necessary, rotate the sleeve slightly so that the push handle
tubes become loose again. Adjust both sides to the same level.
•
First move just one seat half to the required width, you can use the
number scale on the seat surface as a guide (Fig. 14).
•
Then re-tighten the front and rear fixing screws for this side under
the seat.
14.
•
Then push the other seat half to the required width.
•
Re-fix the screws under the seat and then the screws of the sleeve
on the push handle. Use medium-strength screw lock liquid to do
this.
•
You can re-tighten the hook and loop fasteners (Fig. 11) and refit
all other attachments.
•
You should then use a readjusted seat cushion and back cushion.
Make sure that both halves of the seat are adjusted
15.
evenly.
Seat height
To adjust the seat height, loosen the screws in the right and left brack-
ets and adjust to the height required. Please use medium-strength lock
liquid to fix the screws in place (Fig. 15/16).
Seat height adjustment Reinforcement strut
16.
If it is necessary to adjust the seat height, the supplied reinforcement
strut must be used.
This is to be fitted when the seat height is raised to such an extent,
that there are 2 holes on top of each other on the left and right side
of the seat brackets above the battery cover, so that the reinforcement
strut can be fitted.
If the seat height is to set even higher, always use the 2 holes on top
of each other in the seat brackets, so that the reinforcement brace is
directly above the battery cover (Fig. 17).
17.
For these adjustments please contact your specialist dealer.
78
Electric wheelchair |
Electric wheelchair |
Seat depth
•
The seat depth can be adjusted.
•
To adjust the seat depth, loosen the backrest fixings, push the back-
rest forwards or backwards and then re-tighten the screws (Fig. 18).
Seat angle - mechanical
This description only applies if you have a configuration with a me-
chanically-adjustable seat angle.
•
The default setting for the seat angle is 0° to the back.
•
The seat angle can be adjusted backwards in steps.
•
To do this loosen the fixing screws on the telescopic profile under
the front of the seat (Fig. 19).
•
Pull the screws out and adjust to the required seat angle.
•
Put the screws into the next possible position and re-tighten them.
Use medium-strength screw lock liquid to do this.
Backrest angle - mechanical
This description only applies if you have a configuration with a me-
chanically-adjustable backrest angle.
•
The backrest angle of your electric wheelchair can be adjusted eas-
ily. You also have the option of folding the backrest fully forwards.
•
In order to fold the backrest, pull the locking pins using the strap
on the backrest and then fold the backrest down (Fig. 20).
•
To adjust to the required backrest angle, pull the strap backwards.
When doing this, hold the backrest firmly with your other hand.
•
Adjust the backrest to the required angle. When you release the
wire, the bolts will click into the holes.
Make sure that both bolts, right and left are
completely in place.
Please note that after these adjustments the tipping
stability may deteriorate.
Bischoff & Bischoff GmbH - 2023 - 09 - 12 - Revision: 4
Ejoy FD
Electric wheelchair |
Ejoy FD XL
Ejoy FD XXL
18.
19.
20.
79
Werbung
