Whirlpool 3LWTW4705FW Installationsanweisungen Seite 3

Tools and Parts
Gather required tools and parts before starting installation.
Tools needed:
Adjustable or open-end
⁄
9
wrench 14 mm ( ")
16
102 mm
4" min
(4" min)
(102 mm)
Wood block
Pliers that open to
44.5 mm (1 ⁄ ")
3
4
Optional tools:
Flashlight
Parts supplied:
NOTE: All parts supplied for installation are in cardboard
insert in the top of the washer.
Cable tie
INSTALLATION REQUIREMENTS
Level
Ruler or measuring tape
Bucket
Drain hose with clamp
Inlet hoses with flat
washers
Plugs and cord lock cover
Alternate parts:
(Not supplied with washer)
IMPORTANT: Use only Whirlpool authorized parts.
WARNING: To avoid electrical shock, disconnect washer from
power source before replacing parts.
Your installation may require additional parts. To order,
please contact the dealer from whom you purchased your
washer or an authorized service company, or visit us at
www.applianceaccessories.com.
If you have:
Overhead sewer
25 mm (1") standpipe
Drain hose too short
Lint clogged drain
"Y" connector
You will need:
Standard 76 L (20 gal.) 990 mm (39")
tall drain tub or utility sink, sump
pump and connectors (available
from local plumbing suppliers)
51 mm (2") diameter to 25 mm (1")
diameter Standpipe Adapter Part
Number 3363920
Connector Kit Part Number 285835
Extension Drain Hose Part
Number 285863
Connector Kit Part Number 285835
Drain Protector Part Number 367031
Connector Kit Part Number 285835
3