IFM Electronic AC2620 Montageanleitung Seite 10

Activation of the periphery fault message of the channels 1 ... 4
According to the following table the parameter bits P1 and P2 are used
to define which measuring channels can trigger a periphery fault mes-
sage. But irrespective of the defined parameters all 4 channels are
always transferred via the AS-Interface.
Channel coding periphery fault evaluation
Parameter bit
P1 P2
0 0
0 1
1 0
1 1
Operation
Check the safe functioning of the unit. Display by LEDs:
• LED yellow (analog 1) on:
LED yellow (analog 1) flashing:
• LED yellow (analog 2) on:
LED yellow (analog 2) flashing:
• LED yellow (analog 3) on:
LED yellow (analog 3) flashing:
• LED yellow (analog 4) on:
LED yellow (analog 4) flashing:
10
PAGE
Periphery fault can be triggered by
channel 1 channel 2
yes
yes
yes
yes
channel 3
no no
yes no
yes yes
yes yes
analog signal in the measuring
range
analog signal outside the mea-
suring range
analog signal in the measuring
range
analog signal outside the mea-
suring range
analog signal in the measuring
range
analog signal outside the mea-
suring range
analog signal in the measuring
range
analog signal outside the mea-
suring range
channel 4
no
no
no
yes