Master/Slave Operation With Several Show Lasers; Dmx Operation - EuroLite LED FE-2000 Bedienungsanleitung

► Automatic mode
1 Press the button MODE so many times until Aut (Aut0-Aut6) is flashing in the display.
2 Use the buttons UP and DOWN to select the number of the desired program.
3 Confirm with the ENTER button. The display indicates menu item running speed.
4 Use the buttons UP and DOWN to adjust the running speed of the program from S 0 (fast) to S 100 (slow).
5 Confirm with the ENTER button.
► Sound control
1 Press the button MODE so many times until Sou (Sou0- Sou 6) is flashing in the display.
2 Use the buttons UP and DOWN to select the number of the desired program.
3 Confirm with the ENTER button.
4 Adjust the microphone sensitivity to the volume of the music with the control SENSITIVITY. The LEDs and the
laser will be switched off after 5 seconds if the volume is too low or if there is no sufficient bass beat.

Master/slave operation with several show lasers

When several show lasers are interconnected (page 21), the slave units can be synchronized and controlled with
the master unit. The units must be set to the corresponding operating modes.
Set all slave units to slave mode: Press the button MENU so many times until SLA is flashing in the display.
1
Confirm with the ENTER button.
2 Set the master unit to the desired show program. The interconnected show lasers will now operate in sync.

DMX operation

► Setting the DMX starting address
For operation with a controller with DMX512 protocol, the show laser is equipped with 7 control channels. To be
able to operate the show laser with a DMX controller, the DMX starting address must be set for the first DMX
channel. The starting address depends upon which DMX controller is being used. Please refer to the controller's
documentation.
1 Press the button MODE so many times until d (for DMX) and a number between 001 and 506 is flashing in the
display.
2 Use the buttons UP and DOWN to set the DMX start address.
3 Confirm with the ENTER button. Now the show laser switches to DMX mode and can be operated via the DMX
controller. A dot will flash when DMX signals are being received. If no control signals are available, the DMX
address set will be flashing.
► Functions in DMX mode
DMX value
Channel 1: laser
000 – 009 Blackout (laser off)
010 – 030 Green laser on
031 – 050 Red laser on
051 – 070 Green + red laser on
071 – 160 Automatic running light with green + red laser
161 – 255 Sound-controlled running light with green + red laser
Function
23 • EN