Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Control Panel
A
B
Led interface accessory
(1)
Display backlighting +12V
SETTING PARAMETERS USING THE REMOTE CONTROL
Turn knob B
Press knob B
Press button A or C
KEY TO FIGURE MENU
1
Enduser
2
Commissioning
The following procedure is used to access the four boiler
programming menus:
from the main menu
A and C (hold down for approx. 6 seconds)
B
menu 1-2-3-4
C to go back one menu at a time to the main menu.
When the Control Panel is wall-mounted enable the room sensor and
A) ROOM SENSOR
Access menu 2.
B
Operator unit
B
programme row 40 (Used as)
B (anti-clockwise)
C to return to the previous menu then
B
programme row 5977 (Function input H5) then
B
None
B
B) FLOW TEMPERATURE MODULATION
Access menu 2.
B
Temps / mode CH1
B (anti-clockwise)
temperature, parameter 742 has not been set correctly.
Access menu 2 as indicated at the beginning of this section.
B
B
Yes then
B
7115213.01 (4-10/14)
A1
Base for wall-mounted Control Panel
B1
Base for Led interface accessory
(2)
Earth connection
SYMBOLS FOR REMOTE CONTROL
3
Engineer
4
OEM
C.
B
B.
Room unit 1
B
B
742 (HC1). Proceed as follows:
B
"---" then
B
B
B
B
programme row 6200 then
Display shows
Press button A and knob B together
Press buttons A and C together
B.
B
B
742 (Flow temp setpoint room stat)
B.
32
(3)
Power input/Signal +12V
as follows:
B
Werbung
