Commissioning; A) Open/Remove Car Body - Reely 1547808 Bedienungsanleitung

9. Commissioning

a) Open/Remove Car Body

Pull out the two safety clips (A) at the rear end of the vehi-
cle and carefully fold the car body forward.
There is a power cable between the LEDs on the top of
the vehicle and the receiver. Ensure that it is not damaged.
If the cable (B) can be unplugged, pull the associated plug
(C) from the receiver.
Remember the proper alignment (all black cables of the
steering servo, speed controller and LED lamps point to
the same side).
Now the car body can be tipped all the way forward.
To completely disconnect the car body from the chassis,
first turn out the two little screws (D) at the joint between
the car body and the chassis with a suitable cross-head
screwdriver.
Then the car body can be removed from the chassis.
During assembly, observe that the plug (C) of the LED lamps is correctly connected to the receiver (all
black cables of the steering servo, speed controller and LED lamps point to one side).
40