Toro 75500 Bedienungsanleitung Seite 29

Adding Gear Oil
Oil Type: SAE 90 gear oil
Gearbox Capacity: 200 ml (6.8 fl oz)
The rear axle gearbox requires no maintenance.
However, additional oil may be added if oil loss occurs.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the machine and remove the key.
3. Remove the plug from the gearbox.
Figure 27
4. Fill the gearbox with oil.
5. Install the plug.
Mower Maintenance
Servicing the Cutting
Blades
To ensure a superior quality of cut, keep the blades
sharp. For convenient sharpening and replacement,
keep extra blades on hand.
Before Inspecting or Servicing the
Blades
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the machine and remove the key.
3. Raise the machine off the ground so that you
can access beneath it. Support the machine
using jackstands.
WARNING
g392333
Mechanical or hydraulic jacks may fail to
support the machine and cause serious
injury.
Use jack stands when supporting the
machine.
Inspecting the Blades
Service Interval: Before each use or daily
1. Inspect the cutting edges
2. If the edges are not sharp or have nicks, remove
and sharpen the blade; refer to
Blades (page
3. Inspect the blades, especially in the curved area.
4. If you notice any cracks, wear, or a slot forming
in this area, immediately install a new blade
(Figure 28).
1. Cutting edge
2. Curved area
27
(Figure 28).
Sharpening the
29).
Figure 28
3. Wear/slot forming
4. Crack
g006530