Toro 75500 Bedienungsanleitung Seite 17

Height-of-Cut Lever
Use the height-of-cut lever to lower and raise the deck
from the seated position. Moving the lever toward you
raises the deck from the ground and moving the lever
away from you lowers the deck toward the ground.
Adjust the height-of-cut only while the machine is not
moving.
Specifications
Note:
Specifications and design are subject to
change without notice.
Cutting width
Width without deflector
Length
Weight
Height
Charging time
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
76 cm (30 inches)
80 cm (31 inches)
148 cm (58 inches)
188 kg (414 lb)
106 cm (42 inches)
11 hours
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Before Operation
Performing Daily
Maintenance
Before starting the machine each day, perform the
Each Use/Daily procedures listed in
(page 22).
Using the Safety-Interlock
System
WARNING
If the safety-interlock switches are
disconnected or damaged, the machine could
operate unexpectedly, causing personal
injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock
switches daily and replace any damaged
switches before operating the machine.
Understanding the
Safety-Interlock System
The safety-interlock system is designed to prevent the
machine from starting unless:
•
The blade-control switch (PTO) is disengaged.
•
The parking brake is disengaged.
•
You are seated in the operator's seat.
•
The drive-mode switch is in the F
N position.
EUTRAL
The safety-interlock system also is designed to
prevent the mower blades from engaging unless the
drive-mode switch is in the F
Testing the Safety-Interlock
System
Test the safety-interlock system before you use the
machine each time. If the safety system does not
operate as described below, have an Authorized
Service Dealer repair the safety system immediately.
1. Sit on the seat, engage the parking brake, move
the drive-mode switch to the F
15
Maintenance
or
ORWARD
position.
ORWARD
position,
ORWARD