Toro 75500 Bedienungsanleitung Seite 25

5. Insert the wire harness connectors into the
control panel hole.
6. Remove the 4 screws securing the cover to the
left side of the machine. Repeat for the right
side.
Figure 19
1. Hex-head screw (4 each side)
7. Remove the 3 rear screws from the cover.
Figure 20
8. Remove the 4 top screws from the cover.
9. Carefully lift the cover and set it down next to
the machine.
Note:
You do not need to disconnect the wire
harness from the controls.
g358653
10. Reverse the procedure to install the cover.
Important:
After maintenance, ensure that there
are no open circuits or loose wiring.
g358652
23
Figure 21
Figure 22
g358654
g358651