Fronius TransSynergic 4000 Plasma Bedienungsanleitung Seite 42

Displayed service
Code no.: 13
codes
(continued) Cause:
Remedy:
Code no.: 14
Cause:
Remedy:
Code no.: 15
Cause:
Remedy:
Code no.: 16
Cause:
Remedy:
Code no.: 17, 18, 19, 20 and 21
Cause:
Remedy:
Code no.: 22, 23, 24, 25, 26 and 27
Cause:
Remedy:
Code no.: 29
Cause:
Remedy:
Code no.: 31 and 32
Cause:
Remedy:
Code no.: 33
Cause:
Remedy:
Code no.: 34
Cause:
Remedy:
Code no.: 35 and 36
Cause:
Remedy:
Code no.: 37
Cause:
Remedy:
Code no.: 38 (only with Profibus interface)
Cause:
Remedy:
Code no.: 49
Cause:
Remedy:
Temperature sensor 3 fault
Contact After-Sales Service
Temperature sensor 4 fault
Contact service team
Temperature sensor 5 fault
Contact service team
Temperature sensor 6 fault
Contact service team
DSP fault
Contact service team
HOST fault
Contact service team
DSP fault
Contact service team
HOST fault
Contact service team
Overtemperature in the power source control circuit
Allow the power source to cool down
Temperature sensor 7 fault
Contact service team
DSP fault
Contact service team
HOST fault
Contact service team
PLC or field-bus master not ready
Set „Robot ready" signal and „Source error reset"
Phase failure
Check the mains fuse protection, the mains supply lead and plug
8