Wing Installation - Hangar 9 Ultra Stick 30cc Bedienungsanleitung

15. Secure the aileron cover in the wing using four M3 x 15
self-tapping screws.
16. Thread an M3 nut on one end of the 100mm pushrod.
Slide a clevis retainer (silicone tubing) on a metal clevis,
then thread the clevis on the rod. Thread a nylon ball end
12-turns on the opposite end of the threaded rod, then
snap the aluminum ball into the ball end using pliers.
17. Attach the ball end to the outer hole of the servo arm
using the hardware included with the servo arm. Make
sure to install the M3 washer (included with the kit)
between the head of the screw and ball end. Tighten the
hardware using a 1/4-inch nut driver and 3/32-inch hex
wrench.
18. Connect the clevis to the outer hole of the control horn.
With the radio on and aileron servo centered, adjust
the link to center the aileron. Once set, slide the clevis
retainer (silicone tubing) over the forks of the clevis, then
tighten the nut against the clevis. Use thread lock on the
nut to prevent it from vibrating loose.
19. Install the fl ap servo and assemble the linkage for the
fl ap using the same technique as the aileron linkage.
The pushrod for the fl ap linkage also measures 100mm
in length. With the fl ap servo centered, adjust the link
so the fl ap is in the mid-fl ap position of 1 /
9
(40mm).
www.modellmarkt24.ch www.modellmarkt24.ch
EN
15.
16.
17.
18.
19.
-inches
16
20. Use the radio system to set the fl ap to the up position.
Use the radio to center the fl ap into the neutral position.
21. Use the radio system to set the fl ap to the down position.
Use the radio to set the full defl ection position.
 WING INSTALLATION
1. Slide the wing tube into the wing tube socket.
2. Slide the wing panels together. There will be no gap
between the panels.
3. Fit the dowels on the leading edge of the wing into the
holes in the fuselage.
14
20.
21.
1.
2.
3.