Hangar 9 Ultra Stick 30cc Bedienungsanleitung Seite 12

11. Repeat the previous steps to install all four of the aileron
hinges.
12. Fit the aileron to the wing by inserting the hinges into the
slots in the wing.
13. Check that there is a slight gap between the wing and
the end of the aileron. Use a thin ruler (or similar) as a
spacer so both the left and right ailerons have the same
size gap.
14. Apply thin CA to the top and bottom of each hinge. Once
the CA cures, gently pull on the fi xed surface and control
surface to make sure the hinges are glued securely. If
not, apply additional CA to secure each of the hinges.
15. Prepare the three hinges for the fl ap and place it into
position on the wing.
www.modellmarkt24.ch www.modellmarkt24.ch
EN
11.
12.
13.
14.
15.
16. Check the gap between the fl ap and aileron. Use a thin
ruler (or similar) as a spacer so the gap between the
left and right ailerons and fl aps are the same. Glue the
hinges for the fl aps using thin CA. Once the CA cures,
gently pull on the fi xed surface and control surface to
make sure the hinges are glued securely. If not, apply
additional CA to secure each of the hinges.
 AILERON AND FLAP SERVO INSTALLATION
1. Remove the aileron servo hatch from the wing. Make
sure to keep the string taped to the wing so it doesn't fall
into the wing.
2. Check that the servo mount is glued securely to the
servo cover. If the mount is not secure, use a small
amount of medium CA or epoxy to make sure the mount
is securely fastened to the servo cover.
3. Remove the aileron and fl ap cover from the wing. Use a
toothpick to puncture the covering to locate the holes for
the aileron and fl ap cover screws.
4. Place the aileron and fl ap cover into position. Use a drill
and 5/32-inch (2mm) drill bit to drill the holes in the
servo cover mounts.
12
16.
1.
2.
3.
4.