Multiplex FUNCUB Next Generation Bauanleitung Seite 20

Assembly instructions
16. Assembling the RC components
Use a strip of hook and loop tape to fix the controller
right fuselage side in the pocket provided for this purpose Fig. 30 . The
receiver is located behind the undercarriage mount Fig. 31 . This space
is at an angle to all model axes and is therefore the ideal location for
installing a Wingstabi. First plug the servos into the receiver and then fix
it into place with a piece of hook and loop tape
EN
cable set, it is best to mark one of the two green high-current connectors
and its counterpart (e.g. with a felt tip pen). This ensures there is no
confusion when assembling the model.
Important: When positioning the antennas, make sure that they
cannot be shadowed by the battery, controller or cable.
The next step involves installing the second undercarriage mount
the hook and loop strap
above through the undercarriage mount, then underneath the square
tube and on the other side from bottom to top Fig. 32 . Now raise the
undercarriage mount slightly and then apply Zacki2 ELAPOR
square tube. Now push the undercarriage mount against the already
installed plate. The undercarriage mount should be pressed down firmly
onto the square tube. This creates a large contact surface for the drive
battery (3S 2600mAh).
17. Applying the decals
Now apply the decals. Foam parts should be free of grease and dust. The
individual decal elements have been pre-cut. Be careful when removing
the stickers from the backing, especially at corners and jagged edges.
The sticker can tear easily at these points. Avoid pulling and stretching the
sticker. Likewise, avoid touching the adhesive surface with your fingers.
The correct position of the stickers can be seen in Fig. 33 .
Once all the elements have been glued on, give them a good rub with your
fingers. You can use a hair dryer at the wing tips to avoid wrinkles (make
sure it is not hotter than 70°).
18. Setting tasks
The center of gravity is set to 82 mm behind the leading edge near the
fuselage. There are small hemispheres underneath the wing. Balance the
model with your index fingers on the hemispheres. Influence the balance
by moving the drive battery. When propped up/ held up, the model should
have a slightly lowered nose Fig. 34 . After balancing the model to the
indicated center of gravity, attach a strip of hook and loop tape
battery support. Then stick the counter piece
This prevents it from slipping.
20
/
/
. When using our

. First thread the hook and loop strap from

underneath the battery.
Caution: Carry out all programming work with the propeller
to the
disassembled. Optionally, the motor cables can also be disconnected.
Unintentional start-up of the motor poses a high hazard potential!!!
0Set the rudder deflections as follows:
Aileron: +22 mm / -12 mm
Elevator: +25 mm / -22 mm
Rudder: +28 mm / -28 mm
Landing flaps: Starting position -12 mm
Landing position -75 mm with -10 mm elevator mixed in
㉗
and
Important: The servos must under no circumstances run to the
stop at full deflection. Also make sure that the hinges and pushrod
connectors run smoothly. An overload may damage the servos.
® to the
Once all the deflections have been set correctly and the effective directions
of the rudders have been checked again, you can complete the drive. Now
nothing stands in the way of the maiden flight.
We hope you enjoy it and wish you lots of fun flying your new model.
The Multiplex Modellsport Team

to the