Cameo DROP B1 Bedienungsanleitung Seite 11

This will take you to the submenu for setting the submenu items (see table, select with UP and DOWN, confirm with ENTER, change value or
status with UP and DOWN, confirm with ENTER).
Settings
Wireless = W-DMX settings
Settings
Power Mode = Battery mode
Display = Rotate display
Reverse
Display = Display lighting
Menu Dim = dim down using the controls
DMX Fail = Operating status with DMX signal fault
Power Fail = Operating status in the event of a
White power failure
Dimmer = Dimmer curve
Curve
Dimmer Resp. = Dimmer response
LED Calibra- = Color calibration
tion
Auto Lock = Automatic locking of the controls
IR Remote = Activate or deactivate control by IR
remote control
Factory Reset = Reset to factory settings
W-DMX On/Off On = W-DMX enabled
Off = W-DMX disabled
Reset ENTER = Reset pairing with a transmitter and ready for
new pairing
Standard Function disabled
Eco Approx. twice the battery life at 50% brightness
On Display is rotated through 180°
(e.g. for overhead installation)
Off No display rotation
On Permanently on
Off Deactivation after approximately 1 minute of inactivity
On Spotlight is automatically dimmed on input to prevent
dazzling
Off Spotlight is not dimmed on input
Hold Last command is retained
Blackout Activates blackout
White All the LEDs have 100% output
Off No change to current status
On All the LEDs have 100% output
Linear Light intensity increases linearly with DMX value
Exponential Light intensity can be finely adjusted at lower DMX
values and broadly adjusted at higher DMX values
Logarithmic Light intensity can be broadly adjusted at lower DMX
values and finely adjusted at higher DMX values
S-Curve Light intensity can be finely adjusted at lower and
higher DMX values and broadly adjusted at medium
DMX values
LED Lamp responds abruptly to changes in DMX value
Halogen Spotlight behaves like a halogen spotlight with soft
brightness changes
Red, Green, Blue, Individual color calibration. Cross-mode brightness
White, Amber, UV setting of the 6 LED groups RGBWA+UV with values
from 000 to 255
On Automatic locking of the controls after approximately 1
minute of inactivity. Display shows: "LOCKED"
To unlock: press and hold UP and DOWN simultaneously
for approx. 5 seconds
Off Automatic locking of the controls is disabled
On IR remote control activated
Off IR remote control deactivated
Reset Now? Resetting to factory settings:
Perform reset with ENTER, cancel with MENU
11