Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.3 General risks when using the product
The product, hereinafter referred to as "the measuring system", is manufactured
according to state-of-the-art technology and accepted safety rules. Nevertheless,
improper use can pose a danger to life and limb of the user or third parties, or
lead to impairment of the measuring system or other property!
Only use the measuring system in a technically faultless state, and only for its
designated use, taking safety and hazard aspects into consideration, and observing
this User Manual! Faults which could threaten safety should be eliminated without
delay!
2.4 Intended use
The measuring system is used to measure angular motion and to condition the
measurement data for the subsequent control of industrial control processes.
Intended use also includes:
observing all instructions in these Assembly Instructions and the interface-specific
User Manual,
observing the nameplate and any prohibition or instruction symbols on the
measuring system,
observing
configurations etc.,
observing the operating instructions from the machine or system manufacturer,
operating the measuring system within the limit values specified in the technical
data (Assembly Instructions / User Manual)
2.5 Non-intended use
Danger of death, physical injury and damage to property in case of non-
intended use of the measuring system!
Printed in the Federal Republic of Germany
02/15/2016
the
enclosed
As the measuring system does not constitute a safety component
-
according to the EC machinery directive, a plausibility check of the
measuring system values must be performed through the subsequent
control system.
It is mandatory for the operator to integrate the measuring system into
-
his own safety concept.
The following area of use is especially forbidden:
-
In environments where there is an explosive atmosphere.
-
TR - ECE - BA - DGB - 0052 - 03
documentation,
e.g.
product
insert,
connector
TR-Electronic GmbH 2006, All Rights Reserved
Page 35 of 51
Werbung
