EINHELL HT 2020 F Bedienungsanleitung Seite 12

Anleitung HT 2020-12spr.
GB
Connect the water supply hose (not supplied) to
the inlet of the high-pressure cleaner. The hose
must measure at least 13 mm in diameter. The
water supply must have sufficient pressure to
deliver the quantity of water pumped by the high-
pressure cleaner.
4d
The temperature of the water jet is not to exceed
60°C. The water pressure is not to exceed 10 bar.
Important:
The high-pressure cleaner should be operated
with clean water. Unfiltered water or corrosive
chemical agents will damage the high-pressure
cleaner.
The motor switch must be in the OFF position.
The socket-outlet intended for the high-pressure
cleaner must supply the voltage and frequency
specified on the rating plate.
If the motor stops during operation and does not
start up again, wait 2 or 3 minutes before
switching it on again.
Attaching the handle: Fig. 4
1. Pull the handle completely out of its holder
2. Turn the handle 180°.
3. Re-insert the handle in the holder on the chassis.
4
1
2
12
06.11.2001 14:00 Uhr
5. Operation
3
Seite 12
Open the water tap as far as it will go.
Press the pistol trigger (Fig. 5a) and allow any air
to escape.
5a
With the pistol open, switch on the motor by
pressing the switch.
5b