Fagor HV1 Serie Bedienungsanleitung Seite 124

PROGRAMMING THE OVEN FOR A DELAYED START
You do not want to switch the oven on yet because it is too early but you have to
go out and when you return you would like the oven to have donet its work and
switched off automatically.
1
Push the central
light signal will flash. Unse the "–" and "+" buttons to
set the desired duration time.
For example: 50 minutes.
Push the central
2
light signal will flash. Use the "–" and "+" buttons to
set the time at which you wish the oven to switch off.
For example: 14:30.
The two pilot lights will remain lit up.
3
Carry out the rest of the steps for switching on the
oven, "Operating the oven".
After doing this, the oven will be programmed.
In the example, the oven will switch on 50 minutes
before 14:30 and at 14:30 it will switch off
automatically and will begin to beep. In order to
stop the beeping, put the function button to the "0"
position and push any of the three buttons.
Should there be no-one at home, the beeping will
cease after 2 minutes and the oven will remain
switched off.
NOTE:You may modify the end of cooking and duration times even when the
oven is already on. In order to do this, use the central
position.
We recommend that before definitively programming the oven, you carry out a
trial programming
USING THE TIMER FUNCTION
You may wish to use the timer function both for the oven
or for any other purpose. To use this function, follow the
instructions given below.
Push the central
light flashes. Use the "–" and "+" buttons to set the
desired time.
For example: 30 minutes.
Once this time has passed, the timer will beep. In order
to stop the beeping, push any button.
button and the upper left
button twice and the lower left
button until the upper right pilot
123
button in the and