COOL HEAD RC 100 Gebrauchsanweisung Seite 17

Technical Data( for RC)
5.3 Operating
Setting the temperature
The factory settings may not be changed by the user!
Discard the complete packing material after unpacking the device.
Place the device on top of an even and safe surface which supports the weight of the
device.
Not at any time should you place the device on an inflammable surface (such as: table cloth,
carpet, etc.).
Do not place the unit in the vicinity of open sources of fire, electric cookers, furnaces or
other sources of heat such as e.g., in places exposed to direct sunlight. The heat can
damage the surface of the unit, as well as have a negative effect on the cooling power and
increase the consumption of energy.
In order to avoid compressor errors, do not tilt the unit above 45° during its placement or
transport.
The unit should be placed in a manner that assures the proper circulation of air in order to
guarantee the cooling properties of the unit. A minimum space of 10 cm from walls and other
objects should be maintained.
Do not place the unit in locations with high air humidity or high temperatures, because these
factors can damage the unit.
Before the first use the unit should stand for at least 2 hours before it is connected to the
power source.
The electrical circuit in the socket must be secured to at least 16A. Only connect the unit
directly to the wall socket; do not use any extension cords or power strips.
Position the device in a way so that the power plug is always accessible.
Prior to first use, clean the unit.
Wash the shelves in warm water and a mild cleaning agent prior to placing in the refrigerated
showcase .
Clean the interior and exterior of the unit with a moist, soft cloth. Dry thoroughly.
Insert the plug into a grounded single outlet.
Beverages and food products may be placed in the refrigerated showcase after it has
reached the desired temperature.
The optimal temperature has been set at the factory and is between 2°C and 6 °C.
These settings are appropriate for a working temperature in the refrigerated showcase
between 2° – 12°C.
The temperature indicated on the display is the temperature around the thermometer.
If the user desires to change the factory settings, it is necessary to contact a customer
service agent.
17
ORIGINAL INSTRUCTION
GB