COOL HEAD RC 100 Gebrauchsanweisung Seite 12

Technical Data( for RH)
GB
Pour only so much water that it does not spill over.
Observe water level in the water tray, refill water if necessary.
Before you fill the counter with the desired food, make sure that the set operating temperature is reached.
Do not put food directly on the bottom shelf or intermediate shelf, use appropriate containers or dishes!
WARNING! Hot surface!
During operation some parts of the device become very hot.
To avoic burns, do not touch them with bare hands. Use gloves or potholders to insert or remove hot food.
Switching ON/OFF the interior lighting
6. Cleaning and maintenance
6.1 Safety advice
The device is not suited for direct washing via water jets.
Therefore, you must not use any kind of pressure water jet for cleaning the device!
6.2 Cleaning
In the meantime, prepare the desired hot food and put in the appropriate max. 40mm deep
2/1 GN containers (GN containers not included).
Open the sliding glass door of the counter into the opening provided at the bottom of the
conter. Foods, such as pastries, prepared small portions, etc. can be put into suitable
containers or plates, serving platters and placed on the intermediate shelf.
Close the glass sliding doors of the counter to reduce the temperature loss in the counter.
The food is kept warm at the set temperature.
By reduction of temperature in the counter, the heating is switched on again and the warm-
up control lamp comes on again.
The device is equipped with power socket for other electrical devices (such as a knife or
lamp). This is located next to the power cord on the control panel of the device. When
connecting additional devices bear in mind that the total output of 3500 Watts( including
equipment) should not be exceeded.
If the device is not in use anymore, turn it off by ON/OFF toggle switch. Disconnect the
device from the power supply (pull the plug).
The device is equipped with halogen lighting. Switch this on or off as required with the
provided toggle weitch on the operation side.
Before beginning with repair or cleaning works make sure the device has been disconnected
from power supply and has cooled down.
Do not use any acid agents and make sure no water ingresses the device.
To protect yourself from electric shock, never immerse the device, its cables and the plug in
water or other liquids.
Clean the equipment regularly at the end of the day, during the day if necessary, or
when it is no longer in use.
Disconnect the device from power supply (pull the plug!) and let it cool down before
you start cleaning.
12
ORIGINAL INSTRUCTION