COOL HEAD RC 100 Gebrauchsanweisung Seite 16

Technical Data( for RC)
GB
5. Installation and operation
5.1 Safety instructions
WARNING!Electrical hazard!
The device must only be connected to properly installed single socket with protective contact.
Never yank cord to disconnect from outlet.
Cable must not touch any hot parts.
WARNING!Electrical hazard!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with that of the device (see type
label).
Connect the device only in case of compliance!
Take note of the security advice!
5.2 Installation and connection
The installation and maintenance of the appliance should only be carried out by trained personnel!
See that the cable does not touch any heat sources or sharp edges. Do not let the cable
dangle over the counter edge.
Do not use the device in case it does not function properly, has been damaged or dropped.
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the device or
personal injury, and further, the warranty expires.
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep away the
cable from operating range and do not dunk it into water.
Do not move or tilt the device when in operation.
16
ORIGINAL INSTRUCTION