Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10.
Fitting a support
leg the legs
(corner-core desks and links)
The support leg Πis slid into the
beam of the main desk and faste-
ned from below with a wing nut .
11.
Fitting a link frame
The clamps of the linear connectors
Πconnect to the slots in the desk
frame and the link frame Ž.
12.
Fitting the screen
(aluminium slat-wall)
For this, the desk top needs to be removed or
open.
Insert the adaptor bracker Πand tighten the grub
screw in the adaptor (3 mm Allen key). Slide the
screen Ž into the clamp adapter and align laterally.
Tighten screw on the rear of the bracket
(4 mm Allen key). Fit the plastic trays into the tool
rails (no tools required).
Clamp adaptor ‘: fit the clamp bracket with a
countersunk bolt (DIN 7991, M6 x 16, 4 mm Allen
key) – to hole "a" for 25 mm tops or hole "b" for
13 mm tops. The complete bracket is then pus-
hed onto the desk top, and fastened from below
with a bolt (4 mm Allen key). Slide in the panel ”
and tighten the bolt • ton the rear of the brakket.
12
Werbung
