7.
Fitting the CPU holder
The CPU holder, as shown in pic-
ture 6, is clamped from below.
It can be fitted inside or outside
the leg.
Please note: on electrically height-
adjustable desks, the CPU can
still be fitted inside or outside the
leg, but in an off-set position
(towards the user).
8.
Fitting the modesty panel
The bracket is connected to the
frame from below, either with a
locking plate or into the adap-
tor .
The bolts for this are DIN912, M6
x 40, 5 mm Allen key.
(The locking plate is only used on
desks without adaptors).
Fasten the modesty panel to
the brackets with dome-head-
ed bolts (ISO7380, M6 x 8, 4 mm
Allen key)
9.
Fitting the briefcase ledge
Clamp the frame by means of
the connector to the slotted
holes in the frame of the main
desk, as described in picture 6.
HE (Exterior)
or
11
HE (Interior)
Motor (Interior)