Rehau RAUTOOL G1 125 Bedienungsanleitung Seite 26

RAUTOOL G1 125/160
ASSEMBLY SEQUENCE/ESTABLISHING A COMPRESSION SLEEVE JOINT
1. Cut the pipe into lengths of the required size with a square cut
using a guillotine...
2. Slide the compression sleeve on to the pipe.
Caution!
Internal bevelling must point in the direction of the pipe end that
should be pressed.
4. The insertion time of the fi tting into the pipe can be affected by
maintaining the expansion pressure while the expander head is
fully open (end position during the expansion process).
26
... Alternatively, you can also use the roller pipe cutter.
Caution!
Do not use any type of saw or anything similar! The pipe must be
cut into lengths so that the cut is square and burr-free!
3. Expand the pipe once and, displacing the tool by 30°, a second time.
Caution!
The compression sleeve must not be in the expansion zone. The
minimum distance is 2 compression sleeve lengths. Insert the
expander up to the stop and do not tilt it.
5. Insert the fi tting into the pipe. After a short time, the fi tting sits
securely in the pipe (memory effect).