Rehau RAUTOOL G1 125 Bedienungsanleitung Seite 24

Pressing
The expander set must be removed before pressing. To do this, pull
out the long pin completely and pull the short pins as far as the stop.
Pull out and remove the expander set from the cylinder.
Both cylinders must be connected to the motor via a Y distributor, for
the pressing function. Remove the hydraulic hose used during the
expansion process and connect the Y distributor directly to the motor
via the quick couplings or to the two hydraulic hose couplings.
Caution!
Only hydraulic hose couplings that are properly locked into position
may be pressurised!
The control cable of one of the two compression cylinders must be
connected to the motor (= master cylinder).
Caution!
Only the cylinder connected to the motor (master cylinder) can trigger
the pressing process via the start button.
Slide fi rst the long then the short clamping jaw on to both cylinders.
Fix the clamping jaw on to the cylinder using the 4 long pins.
Caution!
Make sure the clamping jaw sets are correctly aligned (short, fi xed
clamping jaw fl ush with the cylinder edge)!
24