Klarstein BORNHOLM CURVED AMBIENT Bedienungsanleitung Seite 24

EN
24
OPERATION
Commissioning
1. Carefully remove the appliance from the box. Save the carton for storage
during the off-season.
2. Make sure that the on/off button is switched off before connecting the device.
3. The heater must be fully assembled and mounted according to the assembly
instructions.
4. To avoid overloading the circuit, it is better not to share the same electrical
connection with other powerful devices.
Switching on
Connect the device to a power supply. The operating light turns on after a short
humming sound. Switch on the appliance with the on/off button (13). The current
room temperature now lights up on the display.
Time setting
Press and hold the settings (16) and up arrow button (15) simultaneously for three
seconds. The "week" display (6) will blink, indicating that the time setting has been
activated. Choose a week day using the arrow keys. Press the "settings" button
(16) and the "hour" display (5) will blink. Using the arrow buttons (14, 15), choose
the hour again. Press the "settings" button (16) to set the minutes required. Using
the arrow buttons (14, 15), select the minute required and confirm the time set
with the "settings" button (16).
Temperature setting
Press settings (16). The temperature display (17) will blink. Then select the
temperature required with the arrow buttons (14, 15). Confirm using the
"settings" button (16) or refrain from pressing any other buttons for 5 seconds to
ensure the setting are automatically confirmed.
Select power level
Use the down arrow button (14) to select the low heating level. The
will show on the display. Select the high heat setting using the Up arrow (15). The
symbol will show on the display. Alternatively, you can push (21) to switch
between the high and low heat settings.
symbol