Operating Procedure - Dehn DEHNrecord DRC SCM XT Kurzanleitung

Quick Guide DEHNrecord DRC SCM XT

6. Operating procedure

Note: Programme an address on the SPDs to be monitored before use (see 7).
1
Configuration OK
Start sequence (5 sec.)
1
a
LED
FM
21 22
DRC SCM XT automatically loads the last valid monitoring status
2
Monitoring status
All SPDs OK
Replace at least one SPD
Note: When delivered, the monitoring status is set to "Replace all SPDs"
3
Page 5
Boot up
Checking the configuration (DIP switch see 5.)
FM
21 22
21 22
DRC SCM XT automatically starts the test cycle
3
a
Checking the assigned SPDs
LED
3
b
Display of the monitoring status
FM LED
21 22
21 22
e.g. SPD No. 2
Note:
!
Ongoing tests (LED
ctrl button (see 9.)!
Configuration not OK
1
b
LED
FM
21 22
⇒ Configuration see 5.
Status display
Status
3 min.
OK
or
1 min.
LifeCheck faulty,
replace SPD
Configuration faulty
) can be aborted by pressing the