Determination Of Spds To Be Replaced; Manual Abort During An Ongoing Spd Test - Dehn DEHNrecord DRC SCM XT Kurzanleitung

Quick Guide DEHNrecord DRC SCM XT
8. Determination of SPDs to be replaced via the SHOW mode at the DRC SCM XT
If the "Replace SPD" monitoring status has been determined during a test cycle, the SHOW mode is
automatically started.
LED indicates the first SPD to
be replaced
Press the ctrl button when the LED flashes orange and release it after 5 sec. upon the LED
goes out.
Note: If the ctrl button is not pressed within one minute, the SHOW mode is terminated
and the monitoring cycle is restarted.
LED indicates the next SPD to be replaced
(e.g. No. 3)
SPD No.

9. Manual abort during an ongoing SPD test

Test cycle running
Last valid status
indicated
SHOW mode
Number = SPD No. of the surge protective device to be replaced (e.g. No. 2)
SPD No.
Press ctrl button (press long)
> 5 sec.
LED
Abort test cycle
Press button
LED
⇒
Press the ctrl button until the LED goes out, the last valid status is indicated.
LED
LED
1 minute
Press button
No other SPD must be replaced. SHOW mode
finished, a new test cycle is automatically
Last valid status
or
2 sec.
!
FM
Partial statuses determined during
21 22 an aborted test are not
21 22 considered!
started.
Page 8