YASKAWA LA500 Installations- Und Bedienungsanleitung Seite 40

2 Deutsch
Table 1.13 Safe Disable Input and External Device Monitor (EDM) Terminal Status
Input Channel Status
Input 1 Input 2
(H1-HC) (H2-HC)
ON ON
(Close the (Close the
circuit) circuit)
ON
OFF
(Close the
(Open)
circuit)
ON
OFF
(Close the
(Open)
circuit)
OFF OFF
(Open) (Open)
Safety Function Status Monitor
The drive Safety monitor output sends a feedback signal about the status of the Safety function.
The Safety monitor output is one of the possible settings available for the MFDO terminals. If
there is damage to the Safe Disable circuit, a controller (PLC or safety relay) must read this
signal as an input signal to hold the "Safe Torque Off" status. This will help verify the condition
of the safety circuit. Refer to the manual for the safety device for more information about the
Safety function.
It is possible to switch polarity of the Safety monitor output signal with the MFDO function
settings. Refer to Table 1.13
Keypad Display
If the two input channels are OFF (Open), the keypad will flash STo [Safe Torque OFF].
If there is damage to the Safe disable circuit or the drive, the keypad will flash SToF [Safe
Torque OFF Hardware] when one input channel is OFF (Open), and the other is ON (Short
circuit). When you use the Safe disable circuit correctly, the keypad will not show SToF.
If there is damage to the drive, the keypad will show SCF [Safety Circuit Fault] when the drive
detects a fault in the Safe disable circuit. Refer to the chapter on Troubleshooting for more
information.
2 Deutsch
◆
Allgemeine Informationen
Verwenden Sie dieses Handbuch nicht als Alternative zum Technischen Handbuch.
Die in diesem Handbuch genannten Produkte und Spezifikationen und der Inhalt des Handbuchs
können unangekündigt geändert werden, um das Produkt und das Handbuch zu verbessern.
Achten Sie darauf, dass Sie stets die aktuelle Version dieses Handbuchs verwenden. Verwenden
Sie dieses Handbuch, um das Produkt korrekt zu installieren, zu verdrahten, einzustellen und zu
bedienen.
40
Safety Monitor
Output Status
MFDO MFDO
Terminal Terminal
(H2-xx = (H2-xx =
21) 121)
OFF ON
OFF ON
OFF ON
ON OFF
for setting instructions.
YASKAWA TOMPYEULA5001C LA500 Installation and Operation Instructions
Drive
Keypad
Output
Display
Status
Baseblock
Normally
(Drive
displayed
ready)
Safety
SToF
status
(Flashing)
(STo)
Safety
SToF
status
(Flashing)
(STo)
Safety
STo
status
(Flashing)
(STo)
MEMOBUS Register
0020H
READY
LED
bit C
READY:
0
Illuminated
ALM/ERR:
1
Flashing
ALM/ERR:
1
Flashing
READY:
0
Flashing
bit D
0
0
0
1