Hama Color Edge Bedienungsanleitung Seite 7

Warning – Batteries
• Never open, damage or swallow batteries
or allow them to enter the environment.
They can contain toxic, environmentally
harmful heavy metals.
• Remove spent batteries from the product
and dispose of them without delay.
• Avoid storing, charging and using in
extreme temperatures and at extremely
low atmospheric pressures (such as at
high altitudes).
• Ensure that batteries with
damaged housings do
not come into contact
with water.
• Keep batteries out of the
reach of children.
4. Getting Started
Note
Before use, ensure you insert the batteries in
the measuring station rst and then in the
base station.
5. Installation
Note – Installation
• We recommend initially placing the base
and measuring stations in the intended
locations without installing them and
making all the settings described in 6.
Operation – to do.
• Only install the stations once the
appropriate settings have been made and a
stable wireless connection is established.
Note
• The wireless transmission range between
the measuring station and base station is
up to 30 m in open spaces.
• Before installation, ensure that wireless
transmission will not be disrupted by
interference or obstacles like buildings,
trees, vehicles, high-voltage lines, etc.
• To avoid transmission interference, do not
operate adjacent wireless devices on the
same frequency (433 MHz).
• Before the nal installation, ensure that
there is su cient reception between the
intended installation locations.
• When installing the measuring station,
ensure that it is protected from direct
sunlight and rain.
• The international standard height for
measuring air temperature is 1.25 m (4 ft)
above ground.
Warning
• Buy special or suitable installation
material from a specialised dealer for
wall-mounting.
• Ensure that no faulty or damaged parts
are installed.
• Never apply force during installation. This
could damage the product.
• Before installation, ensure that the chosen
wall is suitable for the weight to be
mounted, and make sure that there are no
electrical wires, water, gas or other lines at
the installation site on the wall.
• Do not mount the product above locations
where persons might linger.
• We recommend installing the measuring
station securely on an outdoor wall using the
recess (27).
• Install an anchor, screw, nail, etc. in the wall
of your choice.
6. Operation
6.1 Connection to the measuring station
• When the batteries have been inserted, the
base station automatically searches for a
connection to the measuring station and to
the radio signal.
Note
• The respective symbols will ash during
the connection attempts:
the measuring station,
the DCF signal
• Do not press any buttons during setup.
Otherwise, values may not be transmitted
correctly and there is a risk of value errors
and inaccuracies.
• Do not change the location of the base
station during the search processes.
• The process is completed when the indoor
(8) and outdoor (3) measurement data
is displayed.
6.2 Automatic setting using the DCF signal
• When the base station has been switched on
for the rst time and successful transmission
has been established between the base
station and the measuring station, the clock
will automatically search for the DCF signal.
During the search, the radio symbol ashes.
• Following a successful signal search, the radio
symbol stops ashing and lights up solid.
Note – Time settings
• The search process can take up to 7
minutes. If it fails, the radio symbol
will go out.
• In the meantime, however, you can set the
time and the date manually.
connection to
connection to
7