Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Attention!
Never apply force, and change the gear only when the tool is
!
running down or running out.
Never use tools, such as hammers or pliers to change the gear.
Safety Clutch
The safety clutch should absorb shock and excessive stress. It is an aid
and not an absolute protection. Therefore you have to handle and drill
carefully.
To keep it in good condition, the clutch should slip for a very short
time (max. 2 seconds) in each case only. After excessive wearing the
clutch has to be renewed by an authorized service shop.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel.
After every repair the machine has to be inspected by an
electric specialist. Due to its design, the machine needs a minimum of care
and maintenance. However, the following points always have to be
observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the
machine.
In case of failure, a repair has to be carried out by an authorised
service workshop.
Environmental Protection
Raw material recycling instead of waste disposal
In order to avoid damages on transportation, the power tool has to be
delivered in sturdy packing. The packing as well as the tool and its
accessories are made of recyclable materials and can be disposed
accordingly.
The tool's plastic components are marked according to their material,
which makes it possible to remove environmental friendly and
differentiated because of available collection facilities.
19
Werbung
