IKEA RENLIG FWM7 Bedienungsanleitung Seite 6

ENGLISH
• Do not use connection hoses from an old
appliance to connect it to the water supply.
• The water pressure must be in the limits
(refer to the chapter «Technical data» ta-
ble). Make sure that the local water au-
thority gives you the average mains pres-
sure in your area.
• Make sure that there are no kinks in the
water inlet hose and that the water inlet
hose is not squashed or entangled.
• Before connecting up the appliance to new
pipework or to pipework that has not been
used for some time, run off a reasonable
amount of water to flush out any debris
that may have collected in the pipes.
• Turn the inlet hose on the back of the ap-
pliance to the left or the right to suit the in-
stallation.
• The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose specially designed for this
type of use.
• Before opening the water tap, be sure to
tighten the ring nut well to prevent any
leaks.
Water drainage
• Make sure the end of the drain hose can-
not come unhooked when the appliance is
emptying. This could be done by tying it to
the tap with a piece of string or attaching it
to the wall.
• The drain hose must be placed at a height
of not less than 44 cm and not more than
90 cm. Please refer to the Assembly In-
struction booklet.
Care and cleaning
• Before maintenance, switch off the appli-
ance and disconnect the mains plug from
the mains socket.
• Clean the exterior cabinet of the appliance
with soap and water only, and then dry
thoroughly.
• The washing powder and additive dis-
penser drawer should be cleaned regular-
ly.
• Inspected the pump regularly and particu-
larly if:
– the appliance does not empty and/or
spin
– the appliance makes an unusual noise
during draining due to objects such as
safety pins, coins etc. blocking the pump.
• Never remove the pump cover during a
wash cycle. Always wait until the appli-
ance has drained out the water. If you
have selected an high temperature wash-
ing programme please wait until the water
has cooled down.
• Ensure that the pump cover is securely re-
tightened to prevent any leaks.
6