Herunterladen Inhalt Inhalt Diese Seite drucken

IKEA RENLIG FWM7 Bedienungsanleitung Seite 22

Vorschau ausblenden Andere Handbücher für RENLIG FWM7:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

ENGLISH
Problem
Possible cause
The electronic unbalance detection
device has cut in because the laun-
dry is not evenly distributed in the
drum. The laundry is redistributed
The appliance
by reverse rotation of the drum. This
spinning phase
may happen several times before
starts late or
the unbalance disappears and nor-
does not start:
mal spinning can resume. If, after 10
minutes, the laundry is still not even-
ly distributed in the drum, the appli-
ance will not spin.
Too much detergent or unsuitable
detergent (creates too much foam)
has been used.
Check whether there are any leaks
from one of the inlet hose fittings. It
is not always easy to see this as the
water runs down the hose; check to
There is water
see if it is damp.
on the floor:
The drain or inlet hose is damaged.
The cap on the emergency empty-
ing hose has not been replaced or
the filter has not been properly
screwed in after cleaning action.
The washing programme is still run-
ning.
The door will
The door lock has not been re-
not open:
leased.
There is water in the drum.
The transit bolts and packing have
not been removed.
The appliance
The support feet have not been ad-
produces an un-
justed
usual noise
The drain pump could be blocked.
Too little detergent or unsuitable
detergent has been used.
Unsatisfactory
washing results:
Stubborn stains have not been trea-
ted prior to washing.
Solution
Redistribute the load manually or
load more laundry and select the
spin programme.
Reduce the detergent quantity or
use another one.
Check the water inlet hose connec-
tion.
Replace it with a new one (check
with the After Sales Service the right
spare part number).
Refit the cap on the emergency
emptying hose or screw the filter
fully in.
Wait the end of washing pro-
gramme.
Wait a few minutes until the door
indicator light goes off.
Select drain or spin programme to
empty out the water.
Check the correct installation of the
appliance.
Check the correct levelling of the
appliance.
Check the drain pump. (See "Clean-
ing the pump" for more details).
Increase the detergent quantity or
use another one.
Use commercial products to treat
the stubborn stains.
22

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis