Herunterladen Diese Seite drucken

Jamara Sole 2,4 GHz Gebrauchsanleitung Seite 28

Flugmodell

Werbung

DE - Problembehebung
Problem
Die LED am Heli blinkt ohne aufzuhören
Der Heli reagiert nicht auf die
Steuerbefehle
Der Motor reagiert nicht mehr auf den
Gasbefehl
Der Motor dreht ohne Befehl weiter
Motor läuft nicht, nur die Servos bewegen
sich
Der Heli vibriert stark
Der Heli dreht sich unkontrolliert um die
eigene Achse
Der Heli wandert ohne Befehl vorwärts
oder rückwärts
Der Heli wandert ohne Befehl seitwärts
GB - Troubleshooting
Problem
The LED on the helicopter is blinking
constantly
The helicopter does not react to control
commands
The motor does not react to once moving
the throttle stick.
The motor is turning without giving a
control command
Motor is not working only the servos are
turning
The Helicopter is vibrating more than usual
The Helicopter is turning around its own
axis.
The Helicopter is „rambling" backwards
and/ or forwards without giving any control
The Helicopter is „rambling" to the side
without giving any control
28
Ursache
keine Bindung
Batterien zu schwach
Akku nicht ganz eingeschoben
Akku leer
Gas vertrimmt
Gas vertrimmt
Gas war nicht unten beim einschalten
Defekter Motor oder Kabel
defekte Rotorblätter
Defekte Rotorwelle
Schrauben zu fest angezogen
defektes Heckrotorblatt
defekter Heckmotor
Gyro wurde nicht initialisiert
Heck vertrimmt
Nick vertrimmt
Servoanlenkung zu lang oder zu kurz
Roll vertrimmt
Servoanlenkung zu lang oder zu kurz
Cause
Binding failure
Battery is weak
Battery is may not be connected
Battery is empty
Throttle trim is wrong
Throttle trim is wrong
Throttle stick was not pushed down
Broken motor or cable
Broken rotor blade
Broken main shaft
Screws too tight
Broken rear rotor
Broken rear motor
Gyro is not initialised Heli
Diversion trim is wrong
Nick is not trimmed
Servo linkage too long or too short
Roll is not trimmed
Servo linkage too long or too short
Lösung
neu binden
neue Batterien einlegen
Akku überprüfen
Akku aufladen
Gastrimmung einstellen
Gastrimmung einstellen
Gas runter beim einschalten
Motor tauschen Verkabelung prüfen
Rotorblätter tauschen
Rotorwelle tauschen
Schrauben lösen
Heckrotorblatt tauschen
Heckmotor tauschen
Heli neu ein/aus schalten
Hecktrimmung einstellen
Nicktrimmung einstellen
Servoanlenkung justieren
Rolltrimmung einstellen
Servoanlenkung justieren
Solution
Bind helicopter with transmitter
Charge the battery
Check the battery
Charge the battery
Try trimming the throttle
Try trimming the throttle
Move the throttle stick right to the bottom.
Check cables or change motor
Change blades
Change main shaft
Loosen screws
Change rear rotor
Change rear motor
Switch on/ off
Try trimming the diversion
Trim the nick.
Set the servo linkage
Trim the roll function
Set the servo linkage

Werbung

loading

Diese Anleitung auch für:

03 7550