Restore Factory Settings; Maintenance And Cleaning - eQ-3 HomeMatic IP wired HmIPW-WRC2-2 Installations- Und Bedienungsanleitung

8

Restore factory settings

The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the device, proceed as
follows:
Press and hold down the system button (E) for 4
•
seconds until the LED (E) quickly starts flashing
orange (see figure 9).
• Release the system button again.
• Press and hold down the system button again
for 4 seconds, until the LED lights up green (see
figure 10).
• Release the system button to finish the procedure.
The device will perform a restart. After the restart, you
can again integrate your device into your Homematic IP
system.
9

Maintenance and cleaning

The product does not require any maintenance.
Enlist the help of an expert to carry out any
repairs.
Clean the device using a soft, lint-free cloth that is clean
and dry. Do not use any detergents containing solvents,
as they could corrode the plastic housing and label.
Restore factory settings
45