Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Connect the flight battery.
4. Hold the remote control at least 60 cm away from the model, and then switch on the remote control via the on/
off switch.
5. Leave the model for approximately 3 seconds.
6. Unlock the motor via the motor lock button
7. Move the left-hand joystick fully to the top and back to the lowest position.
8. The connection is now re-established.
9. Lock the motor with the motor lock button .
17. Maintenance
17.1 Spare parts
Important! Only use original replacement parts to replace damaged or worn components.
To view the replacement parts lists, visit www.conrad.com and go to the Downloads section for your product.
17.2 Changing the propeller
M1
Risk of injury! Disconnect the flight battery!
Replace a propeller blade as follows:
1. Carefully pull the spinner from the propeller.
2. Hold the motor axle firmly with a pair of pliers.
3. Carefully remove the defective propeller.
4. While holding the motor axle with the pliers, attach a new propeller of the same type to the motor axle.
5. Attach the spinner to the propeller. Important! Use a low-adhesive glue suitable for EPS.
(R11).
47
Werbung
