Werbung
Verfügbare Sprachen
Verfügbare Sprachen
16. Troubleshooting
16.1 Problems/Solutions
Problem
The model does not respond.
The remote control does not respond.
The remote control turns off straight away or
after a short period.
The model vibrates when the motor is running.
The model does not fly straight in stabilisation
mode.
16.2 Resetting the gyroscope
The built-in gyroscope is required to ensure that the model flies in a straight line. If the default settings are changed
for any reason, the gyroscope must be reset as follows:
Prerequisites: The flight battery is connected and the remote control is switched on and ready for use.
1. Place the model in a completely horizontal position.
2. Press and hold the reset button (R13) for 2 seconds.
3. The gyroscope is now reset.
16.3 Re-establishing remote control/receiver connection
The remote control and receiver are preconfigured during production.
Only perform these steps if the model stops responding to remote control commands.
To re-establish the connection, follow the steps below:
1. If the remote control is switched on, switch it off using the on/off switch (R2) and disconnect the flight battery.
2. Secure the model in place. The propeller must be able to turn freely in the event that the motor turns unexpectedly,
but the model must not be able to take off.
46
Solution
Charge the flight battery.
Check the connections on the model.
Re-establish the connection between the remote control and
the receiver.
Check the remote control batteries.
Check the polarity of the batteries.
Check the on/off switch.
Check the remaining capacity of the remote control batteries.
Check the propeller for signs of damage.
Check that the motor axle rotates.
Reset the gyroscope.
Werbung
