Werbung
Verfügbare Sprachen
Verfügbare Sprachen
9. Assembling the model
A1 A2 A3
This section explains how to assemble the model. The assembled model is shown in fig.
Follow the steps in the specified order.
9.1 Attaching the wing
A1
1. Slide the wing into the fuselage as
2. Secure the wing with the screw. Do not overtighten!
9.2 Installing the landing gear
A2
9.2.1 Front
The weel can be installed in two directions. For your model, the wheel must be tilted to the rear after installing.
Guide the wheel through the slot in the fuselage as far as it will go.
9.2.2 Rear
The rear landing gear can be installed in two directions. For your model, the wheels must have a slight toe-in after
installing (forward tilt).
Insert the landing gear from underneath through the slot in the fuselage as far as it will go.
36
shows.
A1
A3
.
Werbung
