Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INTRODUCTION
GE BP-1 and GE BTP-1 are highly efficient, functional and reliable portable electrical inflators. They
can inflate any objects to a pressure between 10 and 1200 mbar and switch off automatically when
the set pressure is reached.
SUGGESTED USES:
• Dinghies / kites / SUP boards
• Rafts / air mattresses / swimming pool floats / etc.
TECHNICAL FEATURES
ITEM
VOLTAGE
(V)
GE BP-1
12 Vdc
GE BTP-1
12 Vdc
OPERATING THE INFLATOR
INFLATION MODE
1. During inflation the valve must be kept open by a suitable adaptor: choose the correct one among
the supplied adaptors.
2. Install the chosen adaptor onto the hose.
3. Connect the other end of the hose to the inflation port (OUT).
4. Set the desired pressure value on the pressure knob (GE BP-1) or on the manometer (GE BTP-1).
5. Connect the inflator to the power supply using one of the cables.
The inflator is supplied with a cable with cigarette lighter plug and one with alligator clips for
connection to a 12 Vdc battery.
WARNIING
When using the alligator clips, make sure polarity is correct (red is positive).
Otherwise the inflator will not start.
6. Press the ON push button.
7. The inflator switches off automatically when the set pressure is reached.
The inflator can be turned off at any time by pressing the OFF push button.
WARNING
Operate the inflator for 20 minutes maximum, then let it cool down for 10 minutes.
WARNING
Always pay attention to the recommended maximum pressure. Always set the desired pressure value
on the pressure knob or on the manometer.
Avoid over-inflation.
WARNING
When the unit is under pressure, never turn the pressure regulation knob or the manometer an-
ti-clockwise, as this would immediately cause the instrument to break.
AIR FLOW
MAX PRESSURE
(L/minute)
(mbar)
160
1200
420 (turbine)
1000
120 (piston)
CURRENT
FUNZIONS
CONSUPTION
(A)
13
14.5
INFLATION/DEFLATION
INFLATION
Werbung
