Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WARNING
Protect the inflator from sand, keeping it inside the bag provided with the unit: if sand gets in, the
inflator may get jammed.
BATTERY STATUS LED (only for GE BTP-1)
The intensity of a LED placed under the manometer ring shows the battery charge status: full brightness means
fully charged battery, LED off means low battery.
DEFLATION MODE (GE BTP-1 only)
1. During deflation the valve must be kept open by a suitable adaptor: choose the correct one among the
supplied adaptors.
2. Install the chosen adaptor onto the hose.
3. Connect the other end of the hose to the deflation port (OUT).
4. Connect the pump to the power supply using one of the cables.
5. Press the ON push button.
6. During deflation the unit does not switch off automatically.
When the inflatable is completely deflated, press the OFF push button immediately to prevent overheating.
SAND FILTER MAINTENANCE (GE BTP-1 only)
The inflator is equipped with a filter positioned under the deflation port (IN).
It is recommended to keep it clean for a longer life and higher efficiency of the inflator.
For maintenance:
•
Loosen the two screws that hold the filter cover (deflation port – IN) in place.
•
Lift the cover and remove the filter.
•
Clean the filter with compressed air or replace it, if it is too dirty.
•
Reinstall the cover by fastening the screws.
TROUBLESHOOTING
PROBLEM
Wrong connection of the power cord
Inflator will
not start
Inflator will not
inflate/deflate
.
ACCESSORIES
Recommended accessories for use with your inflator are available from your local dealer or authorized service
center.
WARNING
The use of any accessories not recommended for use with this inflator could be hazardous.
POSSIBLE CAUSE
to the battery.
No battery voltage.
ON push button not ON.
Inflator is damaged.
Wrong port connected.
Wrong pressure setting.
POSSIBLE SOLUTION
Make sure polarity is correct
(red is positive).
Check the battery.
Press ON push button.
Contact a SCOPREGA service center.
Connect the inflation hose to the proper port.
Adjust setting on the pressure knob.
Werbung
