Husqvarna Z 242F Bedienungsanleitung Seite 13

CONTROLS
Ignition Switch
The ignition switch is placed on the control panel
and is used to start and stop the engine. On
models equipped with headlights, turn the key
clockwise to ACCESSORY for headlight use.
Choke control
The choke control is used for cold starts to
provide the engine with a richer fuel mixture.
For cold starts the control should be pulled up.
Service Meter
The service meter displays the total operating
time with the blade activated.
At 50 hour intervals of operation, an oil can
icon shows and stays on for two hours before
an automatic reset occurs. To manually reset
the meter, turn the key off and on five times at
one second intervals. To service the engine and
mower, see the Service Journal of this manual.
Blade Switch
To engage the mower deck, pull the knob out;
mower blades are disengaged when the knob is
pressed down.
Fuse
The 20 amp primary fuse is located on the left
hand side of the machine. It is accessed by tilting
the seat forward. The fuse is a flat pin type used
in automobiles.
Cutting Height Lever
To set the deck cutting height, pull the cutting
height lever inwards and move it to the desired
height notch.
IMPORTANT INFORMATION Always raise the
deck to the highest position for transport.
IMPORTANT INFORMATION To obtain an
even cutting height, it is important that the air
pressure in all tires is 15 psi / 103 kPa / 1 bar.
13