VOLTCRAFT VC-524 AC/DC Bedienungsanleitung Seite 68

Follow the steps below to measure the temperature:
Turn on the DMM and select the "TEMP"
measurement mode. "°C" will appear on
the display.
Use the "MODE" to change the tempera-
ture unit.
Insert the temperature probe into the tem-
perature measuring adapter in the correct
polarity. The thermocouple plug can only
be inserted into the measurement adapter
in the correct polarity. Do not use force
when inserting the plug.
Insert the positive terminal on the meas-
urement adapter into the temperature
measurement socket (K) and the nega-
tive terminal into the COM measurement
socket (I).
The temperature will appear on the dis-
play.
"OL" indicates that the measurement
range was exceeded or the sensor was
disconnected.
After measuring, remove the sensor and turn off the multimeter.
If no temperature sensor is connected, the ambient temperature of the
DMM can be displayed using a jumper between the two measurement
sockets ("COM" and "Temp"). As the sensor is located inside the housing,
the display reacts very slowly to temperature fluctuations. This function
helps you check that the DMM is at the correct operating temperature
after storage. An external sensor must be used for quick measurements.
68